Search results

My Stabiltrak light comes on radomly and stays on for no apparent reason. Onstar it saying there is a Stabilitrack and ABS problem. Any ideas?

So my check engine light was going on and off intermittently. Took it to the dealer where they diagnosed that the exhaust flex pipe had a hole in it. Quoted around 1200 bucks for a whole new exhaust. Salesperson said might as well replace the whole thing including the catalytic converter because...

When I start my 2012 sonic and when I accelerate I get what sounds like a Growling noise. Not sure what it is. Its been doing it for awhile. Doesn't seem to effect anything. But its just odd. Sounds almost like one of those big fart cans on the ricers.

My Sonic problems continue. Up until a few months ago I have been pretty happy with my 2012 Sonic LTZ. But the last few months have been a nightmare. Its one thing after another. This thing is high miles 142k. I have now had my car in twice and its going in a third time to the Chevy Dealership...

Probably should have posted it here. Have a 2012 Chevy Sonic LTZ with 140k on it. So after having my engine oil pressure light come on, it was taken to the dealer to have the switch put on. This light hasn't come back on. Today the check engine light came on and I checked the codes and it was...

So after having my engine oil pressure light come on, it was taken to the dealer to have the switch put on. Today the check engine light came on and I checked the codes and it was showing P0004 and P2076. After inspecting the engine I noticed one of the battery terminals was pretty corroded...

So a few weeks ago my Engine oil pressure light came on. I pulled over checked oil it was a quart low. Picked up a quart refilled. Didn't come back on. Brought car in for a oil change 2 weeks ago. Light came on again at a stop. But has since gone off. Would this be a sign of a bad sensor or...

Onstar is showing that there is a problem with my antilock and traction control system and stabilitrak system. Should there be concern or how accurate is this? What could be causing this?!?

So I went to move my Drivers seat today, haven't dont so in awhile. It will not move. It is locked all the way to the back. My suspiscion being something in the track. I did find two pens (no clue how they got there) in the track closest to the passenger side. I got one removed but the other is...

Hello, So my windshield wiper linkage snapped at the alluminum side. I had to rig this to get it to hold just in case it rained. But afraid to turn them on any faster than the lowest setting. How hard is it to remove the whole unit? Would it be easier to buy the whole unit or just the linkage...

I have a local mechanic that is willing to do my front end of my 2012 Sonic LTZ. I ordered the front two struts... ACDelco 506-886 GM Original Equipment Front Driver Side Suspension Strut Assembly ACDelco 506-887 GM Original Equipment Front Passenger Side Suspension Strut For the front...

Well my 2012 Sonic 1.8 Sedan is approaching 89k and she is due for an over hall. I'm looking for a set of rear rotors and pads and a inexpensive set struts/shocks for the front end. So any place where I should be able to get some of this stuff...the car is getting up there so not looking to...

So about a month ago I drive to a store and I get out, I come back out and start my car with the AC on lowest setting and the overheating light comes on. I immediately shut off the car and look at the manual. I turn on the heat full blast...its 90 out and open the windows...and the light goes...

I pulled into a store, went inside, came out and started the car and the overheating temp light came on. I immediately shut the car off. Waited a bit and did what it said to do in the manual...the light hasn't come on again. But when I checked the engine area is was scorching hot! This is on...

On way home tonight fueled up and pulled out and engine oil pressure light came on and doesn't go off now unless engine is pushing over 2k. First time I have seen this. Its been really cold here in Vermont. This in a 2013 LTZ 1.8 auto

Mine has become corroded....want to replace it but dont want to pay 85+ an hour...how hard is it to diy?

Need to change my center console utility recepticle. It is corroded or at least remove it and clean it out. Not sure how I would go about doing this...any help?