Does anyone have experience using vinyl on the wheel bow ties and steering wheel bow

[PetePedroPetey]

I used vinyl for the front and rear bow ties and have extra red left over. The wheel and steering wheel bow ties are much smaller and don't seem to have a deep ridge like the front and rear emblems. It seems like using an exacto knife in these areas would cause damage compared to the big front and rear emblems.

Anyone have any experience putting vinyl over the small bow ties on the wheel center caps and also the steering wheel bow tie?




Sent from my iPhone using Tapatalk

 

[cbutton]

I did my center caps and just used an exacto knife and was careful not to cut to hard


Sent from my iPhone using Tapatalk

 

[cbutton]

Sent from my iPhone using Tapatalk

 

[Breezybro]

Subsonic or James Palmer on the Chevy sonic Facebook page sells precut vinyl bowties for wheels.

Those are really nice looking though, well done!

 

[brittanyhale]

I taped a piece of paper over the symbol and used some pencil lead to rub the symbol, then cut that out and used it as a template to make my own pre-cut pieces.

 

[PetePedroPetey]

Thanks guys! I'll have to do that!!! Maybe my x-acto knife wasn't very sharp so I was pushing too hard.



Sent from my iPhone using Tapatalk

 

[perrymk]

I taped a piece of paper over the symbol and used some pencil lead to rub the symbol, then cut that out and used it as a template to make my own pre-cut pieces.

I did the same.

http://www.sonicownersforum.com/forum/exterior-modifications/15824-chromed-emblems.html

EDIT: forgot to mention, I used silver touch-up paint on the gold bowtie emblem on the key. Works fine.