I was looking into the quick install lip or air splitter lips they have for the Sonic ,I watched alot of you tube on the difference in quality between the above listed there fairly reasonable priced and have decided to go with the all fit lip only thing is they come in 1.5" 2.5" and the fat lip I can't decide between the 1.5"or the mid lip2.5" anyone install one on there RS?????
RS installed EZ lip or All Fit lip anyone did this ?
- Thread starter SoCalRs
- Start date
Josh89
Member
Hello
2.5" Custom lips
Looks good, thinking of doing the same to mine
the all fit ez lip is rubber so dont think it will break to easily they show the scrape test and all that on you tube , the design of licence plate right in front of the inter cooler is kinda strange i might relocate mine like you did
Update I bought the 2.5" all fit lip it was more like a air dam than a splitter I got frustrated do to the fact it was hard to install the way I wanted so I am going to try to salvage the lip somehow the all fit is rigid hard to bend around corners even with the v cuts .....
Update I bought the 2.5" all fit lip it was more like a air dam than a splitter I got frustrated do to the fact it was hard to install the way I wanted so I am going to try to salvage the lip somehow the all fit is rigid hard to bend around corners even with the v cuts .....
Last edited:
Well I did buy the ex lip I made a mistake and bought the large one I was trying to get it to look like a splitter it was not easy getting it to conform to the curves on the RS bumper it was sticky but once you pull it off a few times it will fall off I got frustrated and kept it in the garage the threw the dam thing in the trash it was the all fit lip maybe the ex lip foam should had been better ....
Kvin
New member
ho damn !
mine broke because to fix the lips must screw it on the bumper and it broke around the screws
for the lip, the best is:
https://www.strafedesign.com/products/chevy-sonic-rs-front-splitter
good luck !
mine broke because to fix the lips must screw it on the bumper and it broke around the screws
for the lip, the best is:
https://www.strafedesign.com/products/chevy-sonic-rs-front-splitter
good luck !
LownSlowRS18
New member
Wonder if they have this for the 2018 already
YouBeTailsIllBeSonic
Member
That looks SICK!
I used a samurai lip off of Amazon. Looks super sharp.
Sent from my iPhone using Tapatalk
Sent from my SM-A520W using Tapatalk
sonic-image
New member
LownSlowRS18
New member
That looks sick, but I can’t find anything on amazon would you happen to have a link? Or company name? I checked samari and no luck.. TIA
I used a samurai lip off of Amazon. Looks super sharp.
Sent from my iPhone using Tapatalk
Smarjason
New member
HengJia Auto Parts Universal Fit carbon-fiber Car front bumper spoiler lip ?Splitter Side Skirt Roof Spoiler,100% waterproof protection (2.5 meters, black) https://www.amazon.com/dp/B071S4CK8N/ref=cm_sw_r_cp_api_JC0HBbMJYD27S
You have to cut the inside lip in triangle shapes to make the lip go around the curves of the bumper and look nice. Wasn’t hard at all. Comes with screws and 3M tape.
Sent from my iPhone using Tapatalk
That car looks tough I'm glad it's sick so it can take some names on the street chew them up and spit them.out the tailpipe ....