gasonright
Member
I went the Borla route. I got a price I couldn't resist.
BORLA Cat-Back Exhaust (Pictures-Installed).
- Thread starter gasonright
- Start date
13TurboLTZ
New member
Lookin good! Soundclipsplease
xsonicLTZx
New member
How does it sound? Are you happy with it?
Obviously Tyler
New member
Very nice. The sedans are growing on me
FEARONE
New member
I went the Borla route. I got a price I couldn't resist.
Looks sharp. I'm extremely happy with mine, looks, performance, power etc.
Tweaterben
New member
The whole flow
Got mine in too a few weeks ago. But the system just doesn't do the job considering all the other piping before that is still stock 2" diam. Any ideas what you will throw on to replace them. Cat-cov, exhaust mani, etc...
Got mine in too a few weeks ago. But the system just doesn't do the job considering all the other piping before that is still stock 2" diam. Any ideas what you will throw on to replace them. Cat-cov, exhaust mani, etc...
rdss
Junior Member
If you have basic hand tools, a hack saw (or sawzall is preferred) and jack and jack stand you can get this done in your garage or parking lot in about 30-40 minutes. If you have to have it installed I wouldn't pay more than an hour of shop labor.
rdss
Junior Member
It sure will. The cleanest cut will be with a sawzall (clean, straight and small gap). Midas was happy to see my cut when I brought it to them to weld up the stock exhaust before I traded it in.
sx sonic
New member
This. ^^
It's what I did.
Kind of a pain compared to a saw-z-all but it'll work just fine.
gasonright
Member
Pretty sure it was about $540.00 from Amazon. Installed it with my brother so I bought a 12 pack we worked on as we put it on. Had to cut the stock exhaust just behind the rear axle. Installation was actually very easy.