Neighbors car, I'm helping...OK, clutch will not engage. 84 degrees right now, I have about 93PSI across the high and low side engine off. No engine lights, I have replaced the pressure transducer and have ordered an evaporator temperature sensor/thermistor. Upon removal the thermistor read about 50 ohms at ambient. I put in freezer and verified it changes, up to about 80 ohms. Don't know what it should be for resistance. I have ordered a replacement, be here on 6/11/21.
As I understand it, the engine light should illuminate if the pressure transducer or the thermistor is defective you would get an engine light.
I have jumped across the clutch relay and the system works as advertised. Nice cold air. Pressures, 35 Low, 190 High. I'm starting to think it's a control module.
Any ideas?
Thanks all.
As I understand it, the engine light should illuminate if the pressure transducer or the thermistor is defective you would get an engine light.
I have jumped across the clutch relay and the system works as advertised. Nice cold air. Pressures, 35 Low, 190 High. I'm starting to think it's a control module.
Any ideas?
Thanks all.