Airbag Sensor

[ShyScarf]

I took out the stock passenger seat to put in Racing seats, and the sensor light is on. the sensor is connected to the seatbelt, and the rest was connected to the seat. Is there something I can use to override it?
The part on the seatbelt has the 2 prongs, so airbag resistors are kinda a no go unless theres a female version. I'd rather just close that loop rather than rip out the airbag

 

[ozonetrooper]

 

[ShyScarf]

View attachment 17251

I basically did that with the resistor and the wires from the yellow piece, but it didnt work

 

[ozonetrooper]

Did you try it without a resistor, just jumper the connection as a loop ?

 

[ShyScarf]

I tried pushing the pins together but they didnt work

 

[ozonetrooper]

Can you removed the ab sensor from the oem seat and lay it under the new one ?

 

[cherokeefrogg]

I've removed quite a few airbags from mine. I think I only have the ones in the dash left. I just put a piece of tape over the idiot light about seven years ago and haven't looked back. Did the same for the seat belt light but they're still installed.