SGII readout for oil pressure and/or oil temp

[ahtoxa]

I've looked at the SG's site and they don't list any GM codes to be added to the SGII to show oil pressure or temp.

Do you guys know if it's possible on the SGII using X-Gauge? I recall someone talking about it here on this forum and I gathered it was possible, yet nothing was definitive.

 

[rcmn0022]

I believe that both of those values aren't based on a sensor. They are both a calculated value. The only sensor tied to the oil pressure is a low oil pressure switch.

The oil temperature should closely follow the coolant temperature since there is an oil cooler that runs by using coolant to lower the temperature of the oil.

 

[ahtoxa]

You sure on the calculated values? I'm particularly skeptical of the oil temp being a calculated value.

Now, if there's no oil temp sensor, then that may explain why SG's website didn't show X-Gauge coding to be able to get that readout.

 

[rcmn0022]

According to all the HPTuners stock calibration files that others have shared, the stock setting for Oil Temp Config is ". Calc ECM"