Tail pipe.

[2013 Blue Topaz LT]

I saw a few cool options at an Auto Zone shop earlier today.

I'm not seeking to perform any rad mods nor performance related enhancements but rather add an aesthetic bit to an otherwise rather bland few inches of pipe visible from the rear. The angle down concerns me a little.

If any of you have done this and wanna share what you have done, that'd be cool.

 

[Obviously Tyler]

I wanted to do the same thing. It's tough to find one that'll fit the angle and point straight, and it's too short to cut. I got fed up and ended up buying a catback exhaust :blankface:

 

[SonicBoy24]

If you find a tip you like you can always make modifications for it to stick out right.

Everything from a hacksaw to a power saw can be used to cut the stock exhaust at the appropriate angle so the new tip will sit how you want, not hard.

 

[talldude67]

You have to cut the stock ex pipe tip at the curve, measure about 1 " for the tip to stick out past the bumper, drill 2 offset holes then install 2 hex head mach screws to secure...no need to weld on a tip.

bought the tip @ hot rod shop in Vegas, was exactally 2" inside dia...$12.00..